The correct application of the car cleaning cloths
With the correct application of the car cleaning cloths the best results can be achieved. After opening the shipping box, remove the dispenser box and open the lid. Inside is a resealable package with the soaked wet wipes. Remove the bag and knead briefly to allow the liquid to spread evenly. Tear open the bag at the notch at the top. Then open the ZIP closure so that the wet wipes can be removed from the top.
Close the dispenser box with the lid. Through the round tear-off opening individual wet towels can now be removed.
Clean the soiled surfaces with the wet wipes without pressure and piece by piece. It should always be paid attention to enough moisture of the cloths. If you notice that a cloth is already a bit dry or very dirty, use a fresh cleaning cloth. In this step, any dirt (even dried or stubborn particles) is absorbed.
In the next step take the microfibre cloth and polish with one side the just cleaned surface. Lastly, take the other side of the microfiber cloth and polish the area glossy - the seal will automatically be polished onto the material in this step. (The best result and the fastest processing can only be achieved with the specially adapted microfibre cloth of the GentleMonkeys.)
Do not use on heated surfaces or in direct sunlight.
If the vehicle or the surface (paint, wheels, etc.) with mud, salt, sand or similar be dirty, a conventional prewash is recommended. Subsequently, the wet wipes can be used easily.
Older paints tend to chalk over time. This means that fillers and binders leach out of the paint composite. By using paint care products can be but z. T. optically conceal.
The cleaning performance of wet wipes is so strong that simple paint care products are removed from the surface. Below this, the actual lacquer image appears in the case of old lacquers, which can be spotty in individual cases. It does not concern damage to the paint from the wet wipes.
First test for unremarkable surfaces. In the case of heavy soiling, wipe over the soiled areas several times with a cloth and leave to soak in for a few minutes by placing a wet towel on the affected area for approx. 1 minute. Then polish with one side of the microfibre cloth clean and shiny.